All Lock & Dock laptop trolleys and units feature the patented Eco System V3.0 with reverse EMF protection. Gilkon Eco System V3.0 has a patented electrical relay feature that will not allow any reverse EMF charge to pass through to the power cord. Gilkon Eco System V3.0 is a patented Australian product that is tested and electrically approved in Australia. The approval number is SAA101495EA.

The Gilkon Eco System V3.0 has an IP67 rated industrial quality power switch. There is a bright LED in the push button that can be seen at a distance to indicate the mains power is active. When the LED is flashing the charging cycle is running.

Gilkon Eco System V3.0 has a stainless steel / chrome plated brass start button fitted. It has an IP67 rating that will resist liquid and dust. The start switch design has a further safety feature of using only a very low 5-volt signal to activate the power management system.

The power cord has a moulded rubber grommet to hold the cord in plugged position so that small movements would not unplug the cord inside the trolley. In the event of a more forceful move the IEC socket will allow the cord to detach from the trolley and the timer to avoid severing the cable. Power cables supplied with Eco System V3.0 are heavy duty to resist accidental damage.

Moving a group of laptop computers and the chargers can present occupational health and safety issues. The entire range of Lock & Dock laptop trolleys is ergonomically designed in Australia, with the aim of protecting students and staff.

Schools often have rough surfaces that create problems when wheeling trolleys. Whilst a pump up pneumatic wheel is effective, the continual inflation can be an OH&S problem. Lock & Dock provide at no additional cost, a large soft tyre rear wheel that never needs to be pumped up*.

In the event of damage to a power cord Lock & Dock units have a simple solution. The power cord on the Eco System V3.0 is a standard IEC socket that is a low cost repair. There is no need to replace the complete power management system. No technician is required to replace the IEC cord.